Braun 7000 Series Syncro Pro / Syncro Replacement Combo
Braun 7000 Series Syncro Pro / Syncro Replacement Combo A replacement foil and cutter block, the two pieces fit Braun Syncro shaver models 7505, 7526, 7546, and 7570. These shavers need a new foil and cutter block every 12 to 18 months, depending on toughness of beard and frequency of use. Braun Syncro shavers are noted for their four-way moving head that captures and cuts more hair in fewer strokes. The pivoting head oscillates from side to side, and large foil holes capture more hairs.
Braun 7000 Series Syncro Pro / Syncro Replacement Combo Features
- Replacement pack for Braun models 7505, 7526, 7546, 7570
- Includes foil and cutter block
- Cutter Block should be replaced every eighteen months
- Replacing your blades gives a 25% better shave
- For optimum performance, clean regularly
Braun 7000 Series Syncro Pro / Syncro Replacement Combo Reviews
Save some money and make your foil & CB last longer
I purchased my Braun 7526 Syncro Shaver over a year ago and I have yet to replace the foil or cutter block.
My beard is not thick; however the individual hairs on my face are thick, so I need a good shaver to do a good job. Even though I have been shaving with the same foil and cutter block for a little over a year without any problems, there are a few tricks to make your foil and cutter block last longer. They are as follows:
1. Do not press down hard when shaving (it actually cuts better when you let up on the shaver).
2. Use a pre-shave lotion.
3. Do not use the “Clean and Charge” system after every shave. The alcohol in the refills tends to shorten the life of your foil.
4. Use the Clean and Charge system ONLY when it needs to be recharged. Other times clean your shaver by using the brushes it came with.
5. Reseal the clean and charge refill with the lid it came from after every time you use it. It will last you FAR LONGER. The alcohol dissipates when left open. This will save you a lot of money too!
6. If you must use a lubricant on your shaver, spray the foil and cutter foil with an aerosol spray cleaner like Remington Shaver Saver or some other lubricant.
If you follow some very simple techniques (as mentioned above), you can save a lot of money on refills, foils and cutter blocks.
smooth shave
I didn’t realize how dull my original blades were. I mostly bought this kit to replace the micro screen. My old one had a hole worn in it and the shaver was cutting me. Since it came with the new blade, I replaced both. What a difference! If anything, the shaver works better than new now.
